Neil, Yes, use that 'obvious fix' and trim the blades from the top of the switch.
73, Don W3FPR On 12/21/2019 8:42 AM, Neil Zampella wrote:
Just a heads up: I'm putting together another K2, and planning to build this as a base rig keeping it all low power with the battery option. I got to the part where I'm setting the initial parts on the RF board, then plugging in the front board, and the control board, to the RF board. Discovered a problem with the control board not fitting properly. Apparently the K2 Power Switch on the RF board was not properly modified at Elecraft, or was a 'like replacement'. This switch properly had the leads off the bottom of the switch, but also had six wire connector 'blades' at the top. These blades kept the control board from properly fitting on the RF connectors. The obvious fix is to flush cut the blades off at the bottom of each where they meet the switch case. I don't recall seeing a note about this in the main K2 manual, nor in the latest June 2018 errata sheet. The fix is obvious, but you don't realize its needed until you reach the step where you're putting the three boards together. Hope this helps others before they reach that step. Neil, KN3ILZ
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com