Hi Andy, You are right, that is the missing link.
I already took the SDA100 apart and found out the RS232 receiver MAX202 TTL output was not going anywhere.... Indeed it goes to an internal (open jumper), which also connects to pin 7 and 9. Thanks for helping me out 73 Henk -----Oorspronkelijk bericht----- Van: elecraft-boun...@mailman.qth.net <elecraft-boun...@mailman.qth.net> Namens Andy Durbin Verzonden: zaterdag 16 mei 2020 13:14 Aan: elecraft@mailman.qth.net Onderwerp: [Elecraft] K3(s) SteppIR control "The Y cable is connected to the SDA 100 Data IN, radio port, points 2 (RXD) and 5 (ground)" You also need to link 7 and 9 on the SDA 100 connector. Pin assignments on the SDA 100 connector are not typical RS-232. "PINOUT of 9 pin SUBD DATA IN CONNECTOR 1. Data out RXD 2. RXD to RS232 Radio TXD 3. TXD to Radio RXD 4. TTL Kenwood and active high for Radio CTS 5. Signal Ground 6. 7. TTL version of pin 2 8. NC 9. TTL RXD for Steppir." Andy, k3wyc ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to h...@kpnplanet.nl -- Dit e-mailbericht is gecontroleerd op virussen met Avast antivirussoftware. https://www.avast.com/antivirus ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com