I have a full stack of XVs and just migrated to a K2 for IF. Each of
the XVs has a crystal oven. I notice in the stock config for K2, the
LO power jumper at JP9 is 1-2. (All other jumpers are set as
recommended for K2 IF with 0dBm drive and split paths.) Following the
schematic it seems to imply that the LO and oven will be on only when
the band is selected on the K2. I would prefer to have all the LO
and Ovens be on when K2 is on. It seems that I can achieve this by
switching the JP9 jumper to 2-3. Is this correct? Any downside to
this change? I am running this in my shack to the incremental
current draw is not an issue.
Any thoughts appreciated,
Raj, N2RD
K2 #5613
--
Rajiv Dewan, N2RD
[EMAIL PROTECTED]
FN13fc
--
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com