I'm working on one too, and the flat sides are printed on the board
but you have to look close and use some imagination. There are also
photos of the boards finished in the back of the manual. There's also
looking at the schematic and seeing what connects to what, and
finally some have built K1's and put photos of the boards on the net,
you can look for that kind of info. Hope this is helpful, 73 de Alex
NS6Y
On Jul 12, 2006, at 4:46 PM, Dr. Dan Swartling wrote:
I am half-way through building my K1 #2222 and have hit a stumbling
block. How are trimmer caps C13 and C20 installed? On the revision
E board it is not obvious (to me) which way to orient the flat side.
Dan
--
To make a difference, one must first be different.
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
