Yes. Ken K6MR
From: eric norris via Elecraft<mailto:elecraft@mailman.qth.net> Sent: Saturday, December 12, 2020 11:28 To: donw...@embarqmail.com<mailto:donw...@embarqmail.com>; Don Wilhelm<mailto:donw...@embarqmail.com>; Elecraft Reflector<mailto:elecraft@mailman.qth.net>; N6TV Bob Wilson<mailto:n...@arrl.net> Subject: Re: [Elecraft] Interfacing K2 to KPA1500? Don, et al, Can I assume the same is true of a K2/10 with the AUX IO option? Are they wired the same? 73, Eric WD6DBM  On Sat, Dec 12, 2020 at 9:47 AM, Don Wilhelm<donw...@embarqmail.com> wrote: Eric, The KPA100 RS-232 data appears on pins 2 and 3 of the AUX IO connector with pin 5 being RS-232 Signal Ground. Chassis ground is on pin 1. See the KPA100 manual. DO NOT connect to any other pins of the AUX IO connector, those are internal K2 signals to be used by external devices such as the KAT100 or XV series transverters. I can't help with the KPA1500 end. 73, Don W3FPR On 12/12/2020 8:05 AM, eric norris via Elecraft wrote: > The KPA1500 Manual mentions using a K2 with serial interface for band data, > but does not show how to wire it (that I can find). I can't find it in the > nabble archive either. Does anyone know how to do this? > Thanks and > > 73, Eric WD6DBM ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to k...@outlook.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com