KAT500 mode is any mode - current mode is auto, but any mode change does
not make any difference in ability to change from the #2 antenna
position.
haven't tried to erase all my settings and revert back to factory
default settings...yet. I was only going to do that as a last resort.
Lance, KK4DX
------ Original Message ------
From: "Andy Durbin" <a.dur...@msn.com>
To: "elecraft@mailman.qth.net" <elecraft@mailman.qth.net>
Sent: 6/13/2021 8:40:30 PM
Subject: [Elecraft] KAT500 Tuner antenna selection stuck in #2 position
"I cannot change the antenna selector via the front panel of the KAT500 or the
utility software."
What was the KAT500 mode when you observed this problem? There is a known
firmware defect that may prevent enabled antennas being selected when mode is
BYP. The same problem does not exist if mode is MAN and state is Bypassed.
Until this is fixed the solution is to avoid mode BYP (Mode MAN and state
bypass is electrically identical).
73,
Andy, k3wyc
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to lstr...@optonline.net
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com