Hi Jerry,
Your advice is good. I never did get that soldering iron technique to
work for stripping the toroid wire. I used the fine sandpaper supplied
with the K2 to manually bare each wire end. After I soldered, for each
connection, I checked using an ohm meter for continuity between solder
pads at each end of the toroid wire on the board (not between the
wires). I figured this should confirm that the toroid wire was in fact
connected to its solder pad.
73,
Murray VA1CQ
--
This email has been checked for viruses by AVG.
https://www.avg.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com