"So if the Asian manufacturer considers 4 mm easier and close enough the pin will be oversize. WW II drawings give the pin diameter as max/min 0.158/0.154 ."
Isn't 4.0000 mm = 0.1575 inch? If so, 4 mm is within the quoted WWII spec size range. The problem would not be specifying 4 mm but the tolerance that was placed on that measurement. 73, Andy, k3wyc ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com