I was unable to try Jack’s suggestion of disconnecting the AUXIO cable - doing so made the KPA5000 not able to go into Operate mode. So, I wanted to do the other option he mentioned - changing the “radio” setting of the KPA to Serial or Analog. Unfortunately, I have no idea where that setting is. It isn’t in my version of the KPA Utility: V1.19.9.6. I sent Jack an email about it but he’s evidently off-line. Anyidea where that setting might be found?
My KPA shows the correct band on its display. The failure ONLY happens with the K3 powered off. When it is powered up and set to the correct band, the audio level in the IC-705 does not change when switching the amp from operate to standby. Jim / K7TXA > On Mar 31, 2022, at 4:39 PM, Andy Durbin <a.dur...@msn.com> wrote: > > "However, what I’m seeing is that when the amp is in OPER mode, my receive > signal strength drops way, way off to the point I have to go full AF volume > to hear signals. If I put the amp in STBY, signal levels go back to normal." > > These exact symptoms have been associated in past reports with a failure of > the TR switch PIN diodes. Jack's idea of incorrect band can be easily > confirmed, or eliminated, by looking at the KPA500 band display. > > Andy, k3wyc > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to w6...@me.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com