On 11/5/2024 9:13 AM, Pete Smith N4ZR wrote:
They have been quite helpful, though I will NEVER understand their
failing to publish schematics since the K3 era.
Pete,
KPA500 schematics are (were) available on-line. At least I have a copy
that I downloaded in March 2011
> On 11/5/2024 8:57 AM, David Olean wrote:
>> I figured that I would ask a few questions to get
>> me pointed in the right direction. Can anyone help out?
Dave,
Check your e-mail
73,
... Joe, W4TV
On 11/5/2024 9:13 AM, Pete Smith N4ZR wrote:
Dave, you're probably better off asking Elecraft directly (if you
haven't done so already). They have been quite helpful, though I will
NEVER understand their failing to publish schematics since the K3 era.
73, Pete N4ZR
On 11/5/2024 8:57 AM, David Olean wrote:
I have a KPA 500 that is hardly ever used. I think I made less than
ten contacts with it. As a result, I am not that familiar with it
except that it worked great. I loaned it out to a friend and it came
back broken. I am trying to figure out what happened. When I key the
radio I see about 0.6 amps of idle current. TX Signals will pass thru
OK on standby, but if I try transmitting into the amp, I see a high
input VSWR and the idle current stays constant at 0.6 amps. There is
no output power. It seems that maybe the input TR switch may be at
fault. Question: What is the proper idle current for the FETS as
displayed on the screen? If I had a schematic, I could dig into it,
but not having that, I figured that I would ask a few questions to get
me pointed in the right direction. Can anyone help out?
Dave K1WHS
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
