Kieth, The larger flat side is the one you should line up with the silk-screen on the PC board. Unless the trimmers have been recently changed, the smaller 'flat-side' is only the width of the solder lead from the capacitor. The general shape of the trimmer capacitor should match the trimmer body as closely as possible.
For the KPA100, the orientation will not really make much difference. The wattmeter trimmer does not have a grounded side and must be adjusted with an insulated tool and the capacitor on the 4 MHz oscillator is not critical except that it should be adjusted to a frequency greater than 4 MHz so it does not interfere with reception on the high end of 75 meters. What that amounts to is - If you install them backwards, you may never notice a problem. 73, Don W3FPR > -----Original Message----- > > I'm working on the KPA100. It has 2 ceramic trimmer caps. The > installation instructions say to orient them with their flat side > as pictured on the silk screen. The only problem is both ends > are flat? Which is the true flat side, the big flat side or the > small flat side? > > - Keith N1AS - > - K2 5411.ssb - > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com