Hi Guys,
I've recently developed a problem in #5885. If I select XFIL2 in CW
mode, the signal becomes very muffled, and unclear.
I used spectrogram to check my filter setup, and the signal doesn't
look clean in spectrogram either.
Only XFIL2 in CW is affected. CW reversed is fine, and the SSB
filters seem fine as well.
Listening to WWV, the signal strength on the S-meter goes from 20
over 9, to S-1.
Any help as to what might be the cause?
Thanks!
Don
W0DJC
#5885, KSB2, KNB2, KPA100, KDSP2, K160RX
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
