Oh, and I have checked, and C167 is indeed installed. :) On Wed, Jan 31, 2007 at 11:45:54PM -0500, Jeff Kinzli wrote: > So, I'm finally getting to the transmitter alignment section on K2 #5945. > > With a dummy load, I set power on 40M to 2W, and go into tune mode. I can > never get more than about 0.4W on the K2 display, and my wattmeter barely > moves, which would jive with that also. Moving L1/L2 through their full range > has no effect, the power fluctuates between 0.2 and 0.4W regardless. It's the > same on all bands. > > Current draw is about 0.75A in tune mode. > > I had previously aligned the receiver, and the reciever was listening nicely > on 40M. > > Going through the troubleshooting section, I can't find any problems with the > suggested troubleshooting points. > > One thing that struck me as wierd, is that the two 1% resistors that > Troubleshooting refers to (1.5k and 226 ohm), I think R66/67 (?) both read > 195 ohms, but they are the correct color code and I confirmed that I checked > them before installing. It appears strange to me because the other resistors > read correctly while installed, but these do not. So, perhaps this is my > problem? > > Any ideas? > > Thanks, > Jeff _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
