Thanks to Jerry, WA2DKG, I got past the "Deaf K2" by plugging the speaker into the P5 on the RF board vs. the Control Board. I'm not sure how or where I missed that it should be plugged in there, but it works, so things weren't shorted after all on the KSB2 board.
Now I'm at the "Fine Carrier Balance Adjustment" section (Page 19 in the KSB2 Manual), and am not sure how to "hear" the K2's transmitted signal on a external receiver. Since the K2 is connected to a dummy load, am I to run a short piece of wire from the external receiver and locate it near the dummy load to hear this? Thanks, Steve NE7RD _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
