Or simply move the POWER control, and the output should jump to whatever corresponds to the position of the POWER control up to the full 100 watts, even in TUNE mode.
Ron AC7AC -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Don Wilhelm Sent: Thursday, May 31, 2007 4:14 PM To: Curt Milton Cc: elecraft@mailman.qth.net Subject: Re: Fwd: [Elecraft] KPA100 Failing to Produce High Power Curt, How are you attempting to initiate transmit? If you ae pressing TUNE, then 20 watts is what should be produced - the KPA100 firmware limits TUNE to 20 watts. If you need to try at a higher power than that, you must press TUNE and DISPLAY together. OTOH, if you are already doing TUNE/DISPLAY, then check the KPA100 LPF toroids for the correct number of turns - count the nmber of times the wire passes through the center of the core. 73, Don W3FPR _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com