Hi John,
Both!
The K3 works with the KRC2 for controlling complex antenna or
transverter switching. But it also provides amplifier control signals,
as well as 4 open-drain band-data outputs. These are discussed in the
Owner's manual, in the "Rear Panel" section.
Normally the band-data signals output a 4-bit binary code that works
with 3rd-party band decoders, and/or transverter addresses that you
select on a per-transverter basis. But we could also allow these to be
used as 4 general-purpose, active-low relay enables for small relays,
or as signals you could derive relay drive from. The could be mapped
per-band using a PC utility. This would require additional firmware
that we haven't written, pending a survey of how operators would like
to use them.
73,
Wayne
N6KR
On Oct 24, 2007, at 4:29 AM, John Reilly wrote:
Is the functionality of the KRC2 built into the K3, or is it still
necessary for interfacing to amplifiers and antennas?
- 73. John. WØJFR
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com