Paul,
The settings you give are identical to what I'm using, however you didn't
mention setting the K3 CONFIG parameter PTT--KEY to OFF - dtr.
This will match the settings you have in N1MM logger.
73, Van W1WCG
K3 #42
----- Original Message -----
From: "Paul" <[EMAIL PROTECTED]>
To: <Elecraft@mailman.qth.net>
Sent: Thursday, December 13, 2007 1:38 PM
Subject: [Elecraft] K3 and N1MM Logger
I can get N1MM to see the K3. I am switching logging software, for the
K2 I used WriteLog. The frequency and mode show in the title bar for
N1MM. However, I can NOT get N1MM to send CW. to the K3. I see the
software thinking it is sending the CW (the stop light gets bright and
then dims).
I am using a serial cable connected to the only serial port on the
computer running Windows XP. This same cable and port were able to load
the firmware. For the N1MM configuration I have set Com1 to Elecraft K3,
and the CW/Other box is checked. In the parameters for this port, I have
DTR set to CW and RTS set to Always on. I have tried other combinations
for the DTR and RTS settings and none seem to work. The CW/PTT port
address is 3F8.
I appreciate guidance from those who have made this work.
73,
:) PK (Paul - K3MZ K2 #3135 K3 #84)
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
