Carey. You still need to do the TX Gain calibration. That's what is causing your error. Page 46/47 of the manual. Set power to 5W and hold TUNE for a couple seconds on ALL BANDS. Then, if you have the KPA3 installed, you need to do the same for ALL BANDS at 50W.
Let me know how it goes. 73 Greg AB7R -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of H. Cary III Sent: Tuesday, January 01, 2008 2:56 PM To: elecraft@mailman.qth.net Cc: Richard AD7FZ Subject: [Elecraft] ERR TXG Message es tnx The reference oscillator is now aligned with WWV - thanks to N0SS, W3FPR, DJ7MGQ, and AD7FZ for responding so quickly - Tom talked me through it thankfully. I just did the Transmitter Gain calibration and get an error message - ERR TXG - on all bands 160-6. So after passing all the tests/checks during the build, I seem to be alignment challenged Even more frustrating is the detail on the error message in the book says "it could affect one or two bands (how about ALL?) and indicates a problem with band pass filter alignment or one of the low pass filters. Could one of the J-pin connectors be the first place to look? BTW, the good news is the receiver in my K3 is absolutely fantastic! One day, it'll all come together... HNY & 73, Cary, K4TM K2-100 #5266 K3-100 #0178 _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
