Hi Mike, there seems to be no DSP Software ? D1 should show 1.48
Try to load the DSP Software again. Thomas, DM7TN K3/100 #78 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Mike Sent: Sunday, January 20, 2008 8:15 AM To: Elecraft@mailman.qth.net Subject: [Elecraft] [Fwd: [Fwd: K3 #0215.....HELP!]] Hi Everyone - I just sent the following to Support, but, as its weekend, guess will be a while before I can expect a reply! Meantime, does anyone on the list have any (helpful) suggestions please? Its only the DSP that didn't update, the MCU went from 1.48 to 1.58, no problem! As I'm on dialup (& Digest) any direct replies welcome. 73, Mike, zl1mh. Further to the info. below.... Rig worked fine until the download. There is nil audio output from the rig on either SP or PH. uC updated ok from 1.47 to 1.58 on the same download. Menu FW REVS shows the following....uC 01.58 d1 00.00 d2 00.00 FL 00.00 dr 00.00 If I go into SQ Menu, only -- shows on the (A) display. There is no available SQ adjustment. HTH! Mike, zl1mh. Greetings folks! #0215 was up & working fine (No PA installed as yet). This morning I went to do a firmware download/update from your website. All goes well on the connection/download etc., I then get the following message(s) when I try to instal the new f/w to my K3. DSP1 f/w file TBOOT7.HEX verified DSP1 f/w file HDSP01.48.HEX verified DSP1 f/w file DTBL0004.HEX verified Sending f/w file TBOOT7.HEX to DSP1 Erasing DSP1 program & table memory Sending f/w file HDSP01.48.HEX to DSP1 Sending f/w file DTBL0004.HEX to DSP1 waiting for MCU reset to complete verifying DSP1 program load Loaded DSP1 f/w version 01.48 Radio responded with version 00.00 On the K3 Display, I get E 000202 Err dse If I sweitch the K3 OFF & ON again, I get the same message on the Display. I am using the USB/Ser adaptor from Elecraft, & have the latest Driver from Prodogy. All appeared fine until this Download! HELP!! (And TIA!!). 73.....Mike, zl1mh. _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com