I have tried semi-QSK, Mike, but still get the XV144 relay clatter at
speeds less than about 24wpm. I can't find in the manual which config
command I need to change the release delay. Can you point me to it
please? I would like to stop the XV144 relays switching between Morse
elements at 18-20wpm.
73
David G4DMP
In a recent message, Mike Harris <[EMAIL PROTECTED]> wrote ...
| I agree there, Bob. Using the K3 with the XV144 on CW, the XV relays
| clatter with every dot and dash which did not happen with the K2. I am
| a bit worried that it can't be doing the XV144 relays much good.
Correct me if I'm wrong but aren't we mixing up two delays here?
Currently there isn't an adjustable "PTT on/carrier up" delay on the K3,
this is the same for the K2, approx 10ms if I remember correctly. But did
I not read that in semi break-in with the K3 you can adjust the release
delay. That should stop the relays rattling.
--
David G4DMP
Leeds, England, UK
------
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
