Hi Bob. I set ALT1 with filter FC of 1000 Hz and about 700 Hz wide. I used this for most digital modes other than FSK-D or AFSK. I set ALT2 with a LO of 900 Hz and a Hi of 2.4 kHz for SSTV. Now all I have to do is recall these on demand when needed.
73 Greg AB7R -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Bob Evans Sent: Sunday, March 09, 2008 6:13 PM To: [email protected] Subject: [Elecraft] Firmware 1.75...WOW! I don't know why I get pleasantly surprised by all the neat little goodies tucked into these revisions, but it is so nice to see improvements and new features showing up on the K3 hardware platform through firmware revisions. Even though I like to think of myself as a CW only op, the SSB TX adjustments sure help. I like the fact that my DSP filter now goes in 100kHz steps rather than 200kHz steps above 2000kHz. I'm still trying to find a use for Alt1/Alt2, but at least it is there when I think of a good use. And the rig just sounds better (that's a qualitative technical term) too. Thanks Elecraft!! Bob K5WA K3 #234 K2 #4687 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
