Bill,
Thanks for the suggestion - it was a case of I should've read the
manual more.
Thanks, Mark M5MDH
----- Original Message -----
From: "aa1o" <[EMAIL PROTECTED]>
To: "MARK HAMPTON" <[EMAIL PROTECTED]>; <elecraft@mailman.qth.net>
Sent: Saturday, March 15, 2008 8:15 PM
Subject: Re: [Elecraft] PA Temperature Sensor problem
Mark,
sounds as if you haven't enabled the PA. check the config menu KPA3 should
be set to nor (not "io nor")
-Bill AA1O
----- Original Message -----
From: "MARK HAMPTON" <[EMAIL PROTECTED]>
To: <elecraft@mailman.qth.net>
Sent: Saturday, March 15, 2008 3:55 PM
Subject: [Elecraft] PA Temperature Sensor problem
Hi all,
#579 went together smoothly but I have a little problem with
setting the PA sensor temperature. I had no problem with setting the
front panel temperature. However, I moved on to do the PA one and moving
the VFO dial does absolutely nothing - its 2 'dashes' where the
temperature should be. I haven't updated the firmware yet so that
could possibly be the problem though is there any other possible problem?
Thanks, Mark M5MDH
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
--
No virus found in this incoming message.
Checked by AVG. Version: 7.5.519 / Virus Database: 269.21.7/1329 - Release
Date: 14/03/2008 12:33
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com