I am posting this for Stan (shown below) who is not yet subscribed to the list.
de Doug KR2Q



Hi All,

I installed KPA3, turned it ON in CONFIG, but no way to Calibrate 50W Wattmeter.
Still stays in WMTR LP. Sticking pins are cut off on KPAI03 Board.
Out of K-3 only Low Power. KPA3 doesn't work.

Any advice, please.

73!  Stan,  K6WG
k6wg at yahoo dot com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

Reply via email to