I found that WMTR LP stays selected until you advance the PWR control beyond 12W, then it shows WMTR HP. I hope that this helps.
73 Stewart G3RXQ On Wed, 19 Mar 2008 06:23:44 -0400, DOUGLAS ZWIEBEL wrote: > I am posting this for Stan (shown below) who is not yet subscribed to the list. > de Doug KR2Q > > > Hi All, > > I installed KPA3, turned it ON in CONFIG, but no way to Calibrate 50W Wattmeter. > Still stays in WMTR LP. Sticking pins are cut off on KPAI03 Board. > Out of K-3 only Low Power. KPA3 doesn't work. > > Any advice, please. > > 73! Stan, K6WG > k6wg at yahoo dot com > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com