As others noted, that is not yet implemented in firmware. However, you still have 1ppm accuracy. Use method 1 or 2 to set the oscillator on frequency.
When it's implemented, method 3 will allow you to get even higher stability by compensating in firmware for the known variation in the 1 ppm TCXO as shown on the compensation data supplied with your 1ppm TCXO. I believe they're shooting for something close to 0.5 ppm. Be sure to save that compensation data in a safe place for later! Ron AC7AC -----Original Message----- Good day to all, First of all: K3 (812) arrived. Ordered 21 Nov 2007 Order confirmation 22 april Sent 24 april Arrived 28 april Let's see if reality meets expectations....(I'll let you know) I've finished the building procedure and in the process of calibration. When calibrating the TCXO (1 ppm) you are told to locate CONFIG:REF CAL menu. No problem so far. The next sentence tells me to tap [1] to change the name to REF xxC. I'm tapping [1], but I'm getting the message "b set". What am I doing wrong here? (see page 47 right column at the bottom of the owners manual) Thanks for replying in advance. 73's, Evert PA2KW _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com