James C. Hall, MD wrote:
I was setting up for using the K3 for FD this year and am having a problem
getting N3FJP FD software to do rig control. This may belong and likely will
go on their reflector as well, but I wanted to see if anyone else has
noticed any problems here. In the software, I choose Elecraft as rig type
and 4800 8-n-1 and the correct com port. Polling the rig fails. I'm just not
sure why. I'm using a Keyspan 4-port serial to USB adapter that we've used
successfully with the K2 for years. It will do CW keying just fine. Curious
Go to the CONFIG menu in your K3, find RS232, and set the baud rate to
match what your computer is set to (or vice versa).
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
