You can display the RIT offset using the disp menu feature while tech md is on. Then you can see the delta F in place of the VFO B. The only downside is that you have to use the small knob to set y our delta f.
On Thu, 2008-07-03 at 12:41 +0100, Stewart Baker wrote: > As far as I can see it is not possible at present. It is fairly > high on my "should be quick to implement" wish list :-) > > 73 > Stewart G3RXQ > On Thu, 3 Jul 2008 04:22:59 -0700 (PDT), K3KO wrote: > > > > Anybody figure out if it is possible to display a delta F value > instead of > > the actual VFO B frequency when in split? > > > > I've found that delta F is quite useful. The actual frequency, > in practice, > > is irrelevant in most split cases. > > > > Made a couple split contacts now on CW. I like the fact that > bset stays on > > so one can tune without having to hold it down continuously -- > like some > > Kenwoods and ICOM's require. > > > > 73 de Brian/K3KO > > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com