Ah Yes.. So it's nearly there. Just a bit more code to allow the delta F to be displayed for VFO B when Split is selected :-)
73 Stewart G3RXQ On Thu, 03 Jul 2008 09:39:12 -0700, Brett Howard wrote: > You can display the RIT offset using the disp menu feature while tech md > is on. Then you can see the delta F in place of the VFO B. The only > downside is that you have to use the small knob to set y our delta f. > > > On Thu, 2008-07-03 at 12:41 +0100, Stewart Baker wrote: >> As far as I can see it is not possible at present. It is fairly >> high on my "should be quick to implement" wish list :-) >> >> 73 >> Stewart G3RXQ >> On Thu, 3 Jul 2008 04:22:59 -0700 (PDT), K3KO wrote: >> >>> Anybody figure out if it is possible to display a delta F value >> instead of >>> the actual VFO B frequency when in split? >>> >>> I've found that delta F is quite useful. The actual frequency, >> in practice, >>> is irrelevant in most split cases. >>> >>> Made a couple split contacts now on CW. I like the fact that >> bset stays on >>> so one can tune without having to hold it down continuously -- >> like some >>> Kenwoods and ICOM's require. >>> >>> 73 de Brian/K3KO >>> >> >> _______________________________________________ >> Elecraft mailing list >> Post to: Elecraft@mailman.qth.net >> You must be a subscriber to post to the list. >> Subscriber Info (Addr. Change, sub, unsub etc.): >> http://mailman.qth.net/mailman/listinfo/elecraft >> >> Help: http://mailman.qth.net/subscribers.htm >> Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
