A second button press is now required to transfer the mode setting. According to the release notes for version MCU 1.87 / DSP 1.69:
"* A->B SWITCH: 1st tap copies frequency only; 2nd tap within 2 seconds copies mode and filter settings." Bob NW8L On Fri, Jul 4, 2008 at 9:56 AM, TMorton <[EMAIL PROTECTED]> wrote: > When making the selection A>B then holding "Split" I notice that the mode > stays where it last was...i.e., 14005 on A and 14180 on B; after A>B the B > vfo is 14005 but remains in USB. I have looked thru the menu selections and > can not find anything to have the modes match after doing A>B...have I > missed something? If not, why not match freq and mode? > 73 > Tom > CX7TT > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com