>From what I can tell, the UPBn; has not been implemented. All you can do is use up; (for 10 Hz on the VFO A) So you must use 200 up;'s (not practical). Then do a swt11; (to swap VFO's). Also use ft1; to turn on split. (That is a number one.) All swh13; does is toggle split on and off.
Bob Serwy - N9RS -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of G4ILO Sent: Saturday, July 05, 2008 3:45 AM To: elecraft@mailman.qth.net Subject: RE: [Elecraft] Split ops? Bob Serwy wrote: > > Yes there is. I use it. > > 'k31;swt13;swt13;k30; > > OK. I mis-remembered the problem I had trying to get this to work. I'm sending SWT13;SWT13;UPB4;UPB4;SWH13; The two VFOs *are* being set to the same frequency and mode, and SPLIT is being engaged, but VFO B is not being set 2KHz higher in frequency. ----- Julian, G4ILO K3 s/n: 222 K2 s/n: 392 G4ILO's Shack: www.g4ilo.com KComm for K2/K3: www.g4ilo.com/kcomm.html -- View this message in context: http://www.nabble.com/Split-ops--tp18282086p18290111.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com