I have the CONFIG: AGC SLP parameter set to 15 also and I think it is not aggressive enough - that is, the volume difference is too large between weak and strong signals.
73, Bud N7CW -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Bob Cunnings Sent: Monday, July 07, 2008 7:18 AM To: S Sacco Cc: Elecraft Reflector Subject: Re: [Elecraft] [K3] AGC Have you tried adjusting the CONFIG:AGC SLP parameter? I've set mine to the maximum value, 15, for flattest AGC slope. Bob NW8L On Mon, Jul 7, 2008 at 8:13 AM, S Sacco <[EMAIL PROTECTED]> wrote: > OK, now that I'm slowly getting my station rebuild to the point where > I'm operating my K3 on a regular basis, I'm noticing that the AGC > seems to be kind of sub-optimal. There are large differences in audio > volume when receiving different strength signals. I have not been > directly comparing the K3 to another receiver, but it keep surprising > me (in a bad way). On a couple of occasions, I had to rip off my > headphones, because it was faster than reaching for the volume > control. > > I seem to remember this being somewhat of an issue with earlier > firmware versions, but I'm running 2.13 at this time. > > Is anyone else having this issue? > > 73, > Steve NN4X > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
