Hi, Gary from Elecraft gave me an important hint and so the rx of my K3 is now working.It seems, that if you are using just one filter(I use the standard 5-pole filter) it must be in slot 1.I thought slot 3 would also be okay, but it wasn´t.So I thought everything was fine then, until I wanted to do the low power calibration again. I couldn´t calibrate my K3 on 30m and above.On some of the bands I had some output, but on 20 and 12m there was no output at all. I did the transmit crystal filter selection again. I don´t have an AM filter installed, but how should I set it(the K3 asks me to do so...)-I can´t transmit without an Am-filter, can I? Any ideas?
73, Chris-OE5CSP -- View this message in context: http://n2.nabble.com/ERR-TXG-tp573367p573367.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com