> What AF settings did you need to get 1V peak i.e. gain hi or > lo and what front panel AF gain?
CONFIG: AF GAIN = HI -30 dBV at 9:00 -20 dBV at 10:00 -10 dBV at 12:00 0 dBV at 2:30 +3 dBV at 3:30 +4 dBV at maximum 1V peak an excessively high headphone level. Even with my noise abused ears, -30 to -20 dBV is a comfortable listening level with the Heil ProSet (200 Ohm transducers) and -10 dBV is almost painful. At 0 dBV (1V peak), I can hear the ProSet across the room. 73, ... Joe, W4TV > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Paul Fletcher > Sent: Sunday, September 07, 2008 1:50 AM > To: elecraft@mailman.qth.net > Subject: RE: [Elecraft] Headphone Output - SSB Mode - Single Tone > > > > > > Joe Subich, W4TV-3 wrote: > > > > DSP is set to 2800, center frequency is 1500 Hz (default). Signal > > source is an XG-2 (50 uV/-73 dBm) and ACG is Slow. > > > > Roughly, > > What AF settings did you need to get 1V peak i.e. gain hi or > lo and what > front panel AF gain? When I run the tests here I'll set the > output using a > scope but just curious. > > 73 Paul > > -- > View this message in context: > http://n2.nabble.com/Added-LIN-OUT-measurements-tp834406p950890.html > Sent from the Elecraft mailing list archive at Nabble.com. > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
