Hi K3 Firmware/software support gurus,
I upgraded from firmware version 2.34 to 2.38. I had left the VOX on
and sometime during the load I put my coffee cup down on the operating
table and the VOX tripped. The firmware load continued with no error
message. I assumed (I know!) that all was OK until I got on a local 10M
net and was told that I was transmitting 100Hz high but audio was good.
I later found that receive on 20M was 100Hz high but transmit was OK.
That is all I checked before remembering the VOX trip during firmware
load. I reloaded the firmware with VOX off and all seems well.
I thought that I should do a test to try and repeat the error. It seems
that VOX is only active during the FPF part of the load and it is easy
to make it fail but I always get an error message.
It may be the cause of some odd problems. Maybe it is possible to kill
VOX during FPF load as happens during MCU and DSP load.
Hope this helps somebody
73
Tony Fegan VE3QF
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
