Brian,
You have to let the AFV value stabilize first, and then the dBV shows the
value compared to the last AFV value. Page 36 of the manual shows more
details.
73 's Steef PA2A
K3 1184
----- Original Message -----
From: "alsopb" <[EMAIL PROTECTED]>
To: <elecraft@mailman.qth.net>
Sent: Tuesday, September 16, 2008 2:47 PM
Subject: [Elecraft] K3 dbV in 2.38
When turning on the K3, the dbV readout (AGC off) reads +99.9. Tech menu
is
on and other parameters one can display are OK.
It doesn't change until I get impatient and start tuning around, turning
menu main on/off or switching between parameters with the VFO B knob. It
is
not clear what brings it to life. ( A two minute wait alone does not do
it.)
After that it works properly.
Anybody else seeing this?
73 de Brian/K3KO
--
View this message in context:
http://n2.nabble.com/K3-dbV-in-2.38-tp1092599p1092599.html
Sent from the Elecraft mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
