OK... May I ask why? I have seen it done in commercial products and I recently did it when I was assembling my SoftRock receivers because of my concerns with the #30 wire breaking. The two reasons I might think of would be any detuning effect or fear of the material used attacking the wire insulation. Any wisdom on this subject out there? I did not see or am not aware of the Elecraft advisory. 73, Bob K2TK [EMAIL PROTECTED] wrote: I have seen the use of dope, sealers and so on strongly discouraged by Elecraft. |
_______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com