A-yup! The correct pin is 6. A corrected manual will be on the web site soon.
The PR6 comes with a pre-assembled cable to connect it to the power and ACC output on the K3. The connection pin was shown for those who will want to remove the connector and add the control wire to an existing connector, such as the connector from an XV transverter. Ron (red faced again) AC7AC -----Original Message----- Head's up on the PR6 6-Meter Manual. On page 3 of the manual it states that the white control wire from the PR6Pre-amp should go to "Pin 6" of the ACC connector. However, the drawing actually shows that wire going to Pin 11, which is highlighted. I ordered one anyway! Terry, W0FM _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com