I thought that the correct pin was 11. Bob
On Thu, Oct 23, 2008 at 10:17 AM, Ron D'Eau Claire <[EMAIL PROTECTED]> wrote: > A-yup! The correct pin is 6. A corrected manual will be on the web site > soon. > > The PR6 comes with a pre-assembled cable to connect it to the power and ACC > output on the K3. > > The connection pin was shown for those who will want to remove the connector > and add the control wire to an existing connector, such as the connector > from an XV transverter. > > Ron (red faced again) AC7AC > > -----Original Message----- > > Head's up on the PR6 6-Meter Manual. On page 3 of the manual it states that > the white control wire from the PR6Pre-amp should go to "Pin 6" of the ACC > connector. However, the drawing actually shows that wire going to Pin 11, > which is highlighted. > > I ordered one anyway! > > Terry, W0FM > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com