Ron Lodewyck wrote:
>
> After clicking on a packet spot which put the K3 in split mode with VFO
> B up 1 Khz I now find that pressing Rev and tuning, simultaneously
> changes BOTH VFOs. If I release the Rev button and tune my VFO A then
> VFO B simultaneously changes by the same amount. Move A up 1.1 Khz,
> then VFO B also moves up 1.1 Khz. Never did this before and cannot find
> a way to unlock this tracking behavior. The only thing I find relevant
> in the K3 User Manual is Config: VFO B>A which displays "Function" but
> I cannot change this to anything else by rotating the VFO A knob.
>
> This behavior only exists on the 20M band - it goes away on all other
> bands. I have turned the radio off and back on and no change. I know
> it must be a QLF on my part but danged if I can figure it out. Any
> suggestions?
>
Not sure, but you might have your VFOs linked on the 20M band. Go to 20M
and push the SUB button until you see "UNLINK".
73,
Barry N1EU
--
View this message in context:
http://n2.nabble.com/VFO-A-follows-VFO-B-tp1399646p1399694.html
Sent from the Elecraft mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
