> I loaned my K3 to K7RI to get ready for Sweepstakes or I'd > try to describe how to view and set the sub receiver filter > configuration from the K3's front panel. I believe it can be > done, I just can't verify the procedure.
Enter the CONFIG menu ... Select FLx GN Press SUB (display will change to SUB # db) Adjust gain as needed Press SUB (display will change to rF # db) SUB designates KRX3 settings, rF designates KRX3 settings 73, ... Joe, W4TV > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Dick > Dievendorff > Sent: Tuesday, November 11, 2008 9:18 PM > To: 'Roy Morris'; elecraft@mailman.qth.net > Subject: RE: [Elecraft] [K3] Setting Filter Gain in KRX3 > > > You can use the K3 Utility filter configuration tool to > verify the filter settings for both main and sub receiver. > From the K3 Utility's "Configuration" tab, click "Edit > Crystal Filters" and click on the Main / Sub Receiver radio > button at the bottom left of the dialog. > > The main receiver filter settings are distinct from the sub > receiver filter settings. Setting the main receiver's > filters does not set the configuration of the sub receiver filters. > > I loaned my K3 to K7RI to get ready for Sweepstakes or I'd > try to describe how to view and set the sub receiver filter > configuration from the K3's front panel. I believe it can be > done, I just can't verify the procedure. > > Dick, K6KR > > > > > > > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Roy Morris > Sent: Tuesday, November 11, 2008 5:47 PM > To: elecraft@mailman.qth.net > Subject: [Elecraft] [K3] Setting Filter Gain in KRX3 > > I have installed the KFL3A-500 filter in slot #5 in both > receivers. When I set main receiver FL5 GN to 6 dB and go to > B SET, the gain sounds about the same in the KRX3 as it does > in the main receiver. Since the dB setting cannot be seen in > B SETdisplay, how do you know the gain settings are the same? > When the main receiver filter bandwidth, offset and gain are > set in CONFIG, does the corresponding KRX3 filter > automatically get set to the same parameters regardless of > filter slot used? Maybe all this can be determined in K3 > UTILITY. Any comments would be appreciated. Roy Morris W4WFB > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com