Bill W4ZV wrote: > > > Which reminds me...I set my power supply to deliver 14.5V at the input to > my K3 terminals under load. Although the power supply specification > says... > > "Supply Voltage/current: 13.8 V nominal during TX. (11 V min, 15 V max). > 17-22 Amps typical in TX (100W). 0.9A minimum RX." > >
What is the voltage off-load when it is set like that? > > ...I would never intentionally run mine at the lower end of that range. > If you have any concerns about overshoot when turning on your power > supply, always turn the PS on a few seconds before the K3. > But the K3 power switch is a "soft" switch isn't it, so some electronics are still connected to the supply even when the switch is off? > I tend to leave my PS on continuously so overshoot is never an issue. > Mine consumes 30VA even when no load is present, so for the sake of the environment everything here now gets switched off at the mains when not in use. The supply cable for the K3 certainly uses less copper than the ones supplied with JA radios. The PowerPole connectors seem a bit wimpy to me as well. ----- Julian, G4ILO. K2 #392 K3 #222. http://www.g4ilo.com/ G4ILO's Shack http://www.ham-directory.com/ Ham Directory http://www.g4ilo.com/kcomm.html KComm for Elecraft K2 and K3 -- View this message in context: http://n2.nabble.com/New-Eham.net-K3-review-by-QRPNEW-tp2218086p2223357.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
