Svend, Is this a newly built K2, or one that used to work and has now failed. Do you have the K60XV option? If it is newly built, check to be certain you have installed C6 (on the bottom of the RF Board near the rear panel) correctly. Its leads should be in the outer holes of the set of 3 holes between L1 and L2.
If you installed the headers for the K60XV option (or the rework eliminators), you must insert the board into J15. Does it receive on 60 meters? If this is a K2 that worked before, there is likely some failure in either in the Bandpass Filter or the Low Pass Filter. Does it transmit on 40 meters? 73, Don W3FPR Svend Spanget wrote: > Hi all. > > My K2 is working fine on 160m, 80m, 30m and 20m but not 40m. I have > switched between ANT1 and 2. RANT is OFF. Nothing helps... > What went wrong for me? > Any settings to check or could it be a hardware failure? > > 73, > Svend OZ7UV > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html