Hi Ken, Thanks!!!
That did it. All is OK now. 73, Bud W3LL ----- Original Message ----- From: Ken K3IU To: Bud Governale, W3LL Cc: Elecraft Reflector Sent: Thursday, March 26, 2009 2:55 PM Subject: Re: [Elecraft] K3 FSK Passband Frequency Hi Bud: If you make sure that the MMTTY Mark freq is set to the same pitch as the Mark freq on the K3, I'm sure you will find that the RTTY signal will appear in the center of the MMTTY screen with the K3 passband centered. 73, Ken K3IU ~~~~~~~~~~~~~~~~~~~~~~~~~~~ Bud Governale, W3LL wrote: I'm using FSK-D. To tune in an FSK signal I need to use Shift to shift the signal to the right of the passband display on the K3 (centered over the right side arrow). This then places the signal in the center of the MTTY display. However, received signals are now about 0.55 KHz higher than spotted reports. If I click on a spot I have to search for the signal. Normalizing the K3 passband puts the signals completely out of the receive passband and nothing is heard or seen in the MTTY display. Is this normal or am I doing something wrong? Bud W3LL w...@arrl.net ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
