Hello, I'm having a problem with my KAT2. I have built the board and I'm on page 17 of the manual where you measure the voltage at pin B. I always get 0 volts here. Here are some other observations:
I have the ATU menu set to CALn, Power set to 5.0, frequency set to 7.100Mhz. After pressing tune: pin B = 0V U4 pin 5 = 3.8V U4 pin 4 = 0V C55 setting 009 With an external wattmeter between the dummy load and Ant 1, it reads 6.5W. Any ideas where to look for the problem? Thanks & 73 Jay W9IUF ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html