When operating in digital A modes after holding the TUNE button, which gives the proper power out indication, the following happens when going into PSK transmit: 1, There is no power out of the K3 2, The ALC readout is showing the usual 3 bars and can be adjusted 3, There is no monitoring tone ( I have the monitor set at 6 to monitor my output signal on psk).
Changing modes to USB and back to Data A mode temporarily fixes the problem until you hold the TUNE button again while in Data A mode. The firmware revisions that have this problems are; 3.44, 3.45 (a special firmware sent to me by Elecraft), and 3.52. Revisions 3.42 and below work fine. Others have reported this but I just wanted to give my $0.02 worth. 73 Dave KD1NA ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html