> 2, The ALC readout is showing the usual 3 bars and can be adjusted Shouldn't you be showing 4-5 bars on the ALC meter? Maybe your audio is insufficient.
John ----- Original Message ----- From: "Dave & Jeanne Robertson" <dar...@comcast.net> To: "Elecraft Support" <supp...@elecraft.com>; "Elecraft" <elecraft@mailman.qth.net> Sent: Saturday, November 07, 2009 7:37 PM Subject: [Elecraft] No output in digital mode > When operating in digital A modes after holding the TUNE button, which > gives the proper power out indication, the following happens when going > into PSK transmit: > 1, There is no power out of the K3 > 2, The ALC readout is showing the usual 3 bars and can be adjusted > 3, There is no monitoring tone ( I have the monitor set at 6 to monitor my > output signal on psk). > > Changing modes to USB and back to Data A mode temporarily fixes the > problem until you hold the TUNE button again while in Data A mode. > > The firmware revisions that have this problems are; > 3.44, 3.45 (a special firmware sent to me by Elecraft), and 3.52. > > Revisions 3.42 and below work fine. Others have reported this but I just > wanted to give my $0.02 worth. > > 73 > Dave KD1NA > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
