Hi Gene, I have the same setup as you (HRD /DM780) and the same thing happened when I upgraded to 3.63. The transmit light stayed on at the end of PSK transmissions. I fixed it by changing PTT options in DM780 to serial port instead of through HRD. This definitely happened after upgrading to 3.63. I don't know if this is a permanent fix as/ /I am worried about conflicts with HRD rig control as it uses the same port. So far so good though.
73, Bob K6GGO // > On 11/25/09 I downloaded latest firmware, MCU 03.63 and DSP1 02.46. > > While using HRD/DM780 for PSK31 I now notice the TX light stays on at > the end of a transmission. The light will not go out and the K3 will > not go into receive unless I tap, xmit, atu tune, rx ant, or ant button. > > When using version 3.44 beta release and same setup all was well. Has > something changed in the new firmware that I need to reset or did I do > something that would cause this? > > Thanks, > Gene W2BXR > K3 1188 > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html