We're looking into this. 73, Wayne N6KR
On Jan 11, 2010, at 7:20 PM, je1...@a1club.net wrote: > Hi folks! > Thank you for suggestions. > > In my previous post, I forgot to say that my K3 works without hi-temp > alarm after warming up (about 30min or so without transmit just > receiving > status). > > So, it's just the same with Jaako's case. > My shack temp was around 15C these days. > > hmmm... > > Atsu, JE1TRV > >> Hi >> >> I have same problem, when shack temperature is below 17 degrees >> Celcius >> >> When PA Temp is higher than 25 degrees C then power is OK. >> >> Jaakko OH1MA / K3 ser. 2952 >> >> >> Hi Elecrafters! >> >> I have problem on my K3/100 (S/N3050, factory assembled). >> When I transmit more than 12W(means hi power amp on) >> within about 30min after mains power on, HI-TEMP alarm >> occur and equipment is forced to set 5W. >> >> No problem at all when hi-power amp is through ( Po<12W ). >> >> Any idea? >> Thanks in advance >> 73, Atsu JE1TRV >> >> > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
