Bugs item #1932724, was opened at 2008-04-02 15:31 Message generated for change (Tracker Item Submitted) made by Item Submitter You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=106744&aid=1932724&group_id=6744
Please note that this message will contain a full copy of the comment thread, including the initial issue submission, for this request, not just the latest update. Category: None Group: None Status: Open Resolution: None Priority: 5 Private: No Submitted By: Nobody/Anonymous (nobody) Assigned to: Nobody/Anonymous (nobody) Summary: report of axis limit violation Initial Comment: y axis limits set @ +1.7 / -40.4 program has y motion of +/- 10.0 in. from home position after mdi input of g10 l2 p2 y-20.0 z-7.0 axis reported a y axis limit violation upon cycle start. I pushed run anyway and the program ran just fine. I checked the motion limits in manual and/or mdi mode with the g55 in effect. the motion limits were correct. I then put the g10 l2 p2 y-20.0 z-7.0 in the program before the line calling the g55. the control ran just fine without error. This seems to be a gui error report as the control moves the machine to the correct soft limits in manual and/or mdi. ---------------------------------------------------------------------- You can respond by visiting: https://sourceforge.net/tracker/?func=detail&atid=106744&aid=1932724&group_id=6744 ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
