On 10/09/2012 10:08 AM, Chris Radek wrote: > On Thu, Oct 04, 2012 at 11:34:26AM -0600, Sebastian Kuzminsky wrote: > >> I just tested this on a fresh sim install of 2.5.1 and it worked >> correctly - touching off to the tool table updated the DRO >> immediately. I wonder what I broke on my mill at home?. > Did you ever figure out what was happening?
I have some more data, and I can reliably reproduce the problem in sim on 2.5. The problem manifests when the tool number is large. On my Bridgeport I use tool numbers 101-104 for a pair of ER collet holders and a pair of drill chucks; tool holders where I change the tool often, the funny tool numbers help me remember to check the diameter & TLO. Start the sim/axis/axis config. Home the machine. Switch to the MDI tab, run 't1 m6 g43'. Switch to the Manual Control tab, touch off Z in g54. Back to the MDI tab, 't101 m6 g43'. Back to the Manual tab, touch off Z to the tool table. The DRO does not update. Back to the MDI tab, 'g43' updates the DRO. Low-numbered tools work, high-numbered tools do not. I'm not sure where the cut-off is. -- Sebastian Kuzminsky ------------------------------------------------------------------------------ Everyone hates slow websites. So do we. Make your web apps faster with AppDynamics Download AppDynamics Lite for free today: http://p.sf.net/sfu/appdyn_sfd2d_oct _______________________________________________ Emc-developers mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-developers
